Difference between revisions of "Main Page"
Jump to navigation
Jump to search
m |
m (→Modes) |
||
| Line 42: | Line 42: | ||
== Modes == | == Modes == | ||
=== Firmware Programing === | === Firmware Programing === | ||
| − | 1- Pressing RST button | + | Button sequence: |
| − | 2- Pressing IO0 button | + | 1- Pressing '''RST''' button |
| − | 3- Releasing RST button | + | 2- Pressing '''IO0''' button |
| − | 4- Releasing IO0 button | + | 3- Releasing '''RST''' button |
| + | 4- Releasing '''IO0''' button | ||
=== Setting LoRa Keys === | === Setting LoRa Keys === | ||
| − | 1- Pressing RST button | + | Button sequence: |
| − | 2- Pressing WEB button | + | 1- Pressing '''RST''' button |
| − | 3- Releasing RST button | + | 2- Pressing '''WEB''' button |
| − | 4- Releasing WEB button | + | 3- Releasing '''RST''' button |
| + | 4- Releasing '''WEB''' button | ||
=== Normal Mode === | === Normal Mode === | ||
| − | + | There is not button sequence. It is by default mode when powering. Coming from other modes, normal mode can be reached pressing '''RST''' button. | |
<!-- | <!-- | ||
Revision as of 23:15, 29 March 2020
Contents
LoRa RMM v3.0
Board
File:RMM 3D v3.0
Caption
caption text text text ...
Connectors
Plastic Box Wall Connectors
SMA
868MHz Antenna plugged at SMA. To avoid malfunctions, it is important to connect antenna before power RMM device up.
4 pin connector
1- 3V3 2- NC (not connected) 3- Rx (MPPT's Tx) 4- GND
PCB Connectors
ANT
uFL connector. SMA / uFL antenna pigtail is connected on ANT.
PRG
J2: Firmware programming connector. Also, it can be used for debugging.
To avoid power supply issues, it is suggested powering device only by COMM connector (J1).
COMM
J1: It is connected to 4 pin external connector.
GND: BLACK RX: RED <- Be careful! Tx: WHITE <-- Not Connected 3V3: YELLOW <- Be careful!
Modes
Firmware Programing
Button sequence:
1- Pressing RST button 2- Pressing IO0 button 3- Releasing RST button 4- Releasing IO0 button
Setting LoRa Keys
Button sequence:
1- Pressing RST button 2- Pressing WEB button 3- Releasing RST button 4- Releasing WEB button
Normal Mode
There is not button sequence. It is by default mode when powering. Coming from other modes, normal mode can be reached pressing RST button.
